Bend-Tech EZ3D

Bend-Tech EZ3D was designed to help out the serious hobbyist.  We took our easy to use EZ product and added a 3D interface.  Our Tri-Star interface is unique in that a customer doesn't need to learn XYZ, it uses terms like front, back, floor, ceiling, left and right.  While you are stepping quickly around the part, EZ3D is calculating your bend angles and rotations.  No more guessing.

As mentioned previously, the EZ3D functions are also available in PRO and SE.

EZ3D is also our introduction to Bend-Tech's simulation.

Simulation offers a quick way to verify a part can be made and also gives the fabricating beginners an opportunity to see how the part is processed through the tooling prior to any tube being cut or bent.  The simulation also forced an additional setup sheet which shows cartoon strip style transitions of the tube being bent.

If your just starting out and have a couple of projects in mind, EZ3D will be a great stepping stone to get you started.

In the graphic below you can watch the part being created as the values are entered in.  Notice how when values are entered into 2 or 3 directions at one time this is defining angles other than 90 degrees and will also define rotations.

More Details....