Header - Details

From Bend-Tech 7x Wiki
Jump to: navigation, search

Bend-Tech 7x Wiki :: Header Design :: Details

Header details.png


In the details tab, a list of every material used in the header design project will be listed along with the material's attributes, such as the name, width, amount used, and weight.

If weight per unit values have been given to the materials in the Tube/Pipe Library, the total weight of the assembly will be shown below the table.


Change Die or Material

Click the All Dies button All dies.png to change all the dies used in the header to one specified die. After clicking the button, select a die from the menu and click the OK button to confirm the die change.


Click the Match Die button Match die.png to replace all bends using a certain die with an alternate die. In the menu, select the die that will be replaced and selected the die that will replace it. Click the OK button to confirm.


Click the All Materials button All materials.png to change all the materials used in the header to one specific material. After clicking the button, select a material from the menu and click the OK button to confirm the material change.


Click the Match Materials button Match material.png to change all the materials used in the header to one specified material. After clicking this button, select a material from the menu and click the OK button to confirm the material change.


Single Bend CLR Change

To adjust the CLR of a single bend, first select a die in the Select Die menu in the Single Bend CLR Change area. Next click the Select Bend button Select bend.png and click on a bend to apply the selected die to it.