Difference between revisions of "Decimal & Fraction"

From Bend-Tech 7x Wiki
Jump to: navigation, search
(Created page with "The "Decimal / Fraction" select box under the "Settings" tab is used to format the results "lengths" or "locations" and the "cut length". If you use a tape measure that has f...")
 
Line 3: Line 3:
 
If you use a tape measure that has fractions you may want to set these values to match up. With all NC or CNC machinery you will want to set it to 2 or 3 decimal places.
 
If you use a tape measure that has fractions you may want to set these values to match up. With all NC or CNC machinery you will want to set it to 2 or 3 decimal places.
  
DecimalFraction1.png
+
[[File:DecimalFraction1.jpg]]
  
  
 
Make sure to change values in the Options menu which can be accessed by clicking the "Tools" menu and selecting "Options". The Decimal/Fraction adjustment menu can be found in the "General" tab, in the Tolerance section under "Lengths".
 
Make sure to change values in the Options menu which can be accessed by clicking the "Tools" menu and selecting "Options". The Decimal/Fraction adjustment menu can be found in the "General" tab, in the Tolerance section under "Lengths".
  
DecimalFraction2.png
+
[[File:DecimalFraction2.jpg]]

Revision as of 15:25, 9 June 2014

The "Decimal / Fraction" select box under the "Settings" tab is used to format the results "lengths" or "locations" and the "cut length".

If you use a tape measure that has fractions you may want to set these values to match up. With all NC or CNC machinery you will want to set it to 2 or 3 decimal places.

DecimalFraction1.jpg


Make sure to change values in the Options menu which can be accessed by clicking the "Tools" menu and selecting "Options". The Decimal/Fraction adjustment menu can be found in the "General" tab, in the Tolerance section under "Lengths".

DecimalFraction2.jpg