Difference between revisions of "My Material or Tooling Library won't Update"
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | My material or | + | My material or die library won't update. |
This is a common question and here is a list as to the reasons why: | This is a common question and here is a list as to the reasons why: | ||
| − | --> You must select the "Add New" button before entering the tooling or material information. | + | --> You must select the '''"Add New"''' button before entering the tooling or material information. |
| − | *When you enter in the material diameter or wall thickness, or the | + | *When you enter in the material diameter or wall thickness, or the achieved clr, calibrated clr or bend location offset you '''MUST''' use a decimal place number. |
| − | + | *No other characters such as symbols or abbreviations. Also do not use text like inches or mms. | |
| − | *No other characters | + | *The material diameter must be greater than twice the wall thickness. Many times a user will put in .95 instead of .095 |
| − | *The material diameter must be greater than twice the wall thickness. | + | *In the material library the dimension under the '''circle''' is the OD of material. |
| − | *In the material library the dimension under the | ||
| − | --> It is okay to leave the weight in the material library as 0 | + | --> It is okay to leave the weight in the material library as 0. |
| − | --> When finished select the "Apply" button. This will update the list on the left hand side. | + | --> When finished select the '''"Apply"''' button. This will update the list on the left hand side. |
| − | --> After you select the "Apply" button, the "OK" button is used to update the list to the hard drive. '''SELECT THE "OK" BUTTON WHEN FINISHED.''' | + | --> After you select the '''"Apply"''' button, the '''"OK"''' button is used to update the list to the hard drive. '''SELECT THE "OK" BUTTON WHEN FINISHED.''' |
Latest revision as of 09:24, 6 October 2015
My material or die library won't update.
This is a common question and here is a list as to the reasons why:
--> You must select the "Add New" button before entering the tooling or material information.
- When you enter in the material diameter or wall thickness, or the achieved clr, calibrated clr or bend location offset you MUST use a decimal place number.
- No other characters such as symbols or abbreviations. Also do not use text like inches or mms.
- The material diameter must be greater than twice the wall thickness. Many times a user will put in .95 instead of .095
- In the material library the dimension under the circle is the OD of material.
--> It is okay to leave the weight in the material library as 0.
--> When finished select the "Apply" button. This will update the list on the left hand side.
--> After you select the "Apply" button, the "OK" button is used to update the list to the hard drive. SELECT THE "OK" BUTTON WHEN FINISHED.
