My Material or Tooling Library won't Update

My material or tooling library won't update.

This is a common question and here is a list as to the reasons why:

--> You must select the "Add New" button before entering the tooling or material information.

   *When you enter in the material diameter or wall thickness, or the tooling clr, calibrated clr or bend location offset you MUST
   *Use a decimal place number.
   *No other characters like " or ' also do not use text like inch or mm
   *The material diameter must be greater than twice the wall thickness. many times a user will put in .95 instead of .095
   *In the material library the dimension under the "circle" is the OD of material. 

--> It is okay to leave the weight in the material library as 0

--> When finished select the "Apply" button. This will update the list on the left hand side.

--> After you select the "Apply" button, the "OK" button is used to update the list to the hard drive. SELECT THE "OK" BUTTON WHEN FINISHED.