View source for XYZ Example 5 (Under 90 Degree Bends, Move in 3 Directions)

In this example, we will show you how to create an open "L" bracket.

'''NOTE: All XYZ locations are based upon a 0,0,0 global location. Which means that each location is referenced to an absolute location. The start point does NOT need to be 0,0,0.'''

While in the XYZ interface:

1) Zero out the '''"Start"''' row to make our start point the center of the locator.

[[File:XYZ5.1.jpg|800px]]


2) In the '''"Bend 1"''' row enter''' "12"''' for '''"X"''', and '''"0"''' for both '''"Y"''' and '''"Z"'''. - This will give us 12" from the start of the tube, to the apex of the bend.

[[File:XYZ5.2.jpg|800px]]


3) In the '''"End"''' row enter '''"20"''' for '''"X"''', '''"10"''' for '''"Y"''', and''' "5"''' for '''"Z'''". - From the apex of the bend, this will put our third point another 8 down the X axis, 10 over on the Y axis, and up 5 on the Z axis.

[[File:XYZ5.3.jpg|800px]]