Cutting the End of a Part

From Bend-Tech 7x Wiki
Revision as of 14:42, 5 October 2015 by Fabcam1 (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

The following are the steps to setting up the cutting the end of a "part" .

Step 1: Select the "Cutting" tab.

Step 2: Select the "New Cut" command button.

Step 3: Select the tube you are going to cut. Note: The straight end of a bent part will have a blue PickPoint on it. Select this PickPoint. You will find our part turn green in color.

CutEnd1.jpg


Step 4: Select the dot(s) representing the tube section(s) that our part is going to be cut to. You will find the intersecting tubes will turn red.

CutEnd2.jpg


Step 5: Select the "Cut Complete" command button.

CutEnd3.jpg


Notice the intersection now has a black and a blue cut marks showing the inside and outside of the material where each meets the intersection part(s).

Step 6: Select the "Print" command button.

CutEnd4.jpg


The cutting templates can be called up at a later time by selecting them from the list shown.